TK Products TK-One Step 5-Gallon Pail

• Non-yellowing
• Faster turnaround with reduced material and labor costs.
• Excellent water repellency and resistance to salt, oil, grease, and stains.
• Protects against freeze/thaw damage.
• Complies with ASTM C-1315, Type 1, Class A, B, & C

TK-ONE STEP™ is a clear, penetrating, acrylic copolymer, siloxane blend, that acts as an easy single-step application to cure, seal, and weatherproofing for new and existing concrete. TK-ONE STEP eliminates excess steps for curing and protecting concrete, allowing a faster return to service for the treated areas, when compared to traditional curing or sealing products. Additionally, the siloxane addition improves the concrete’s water repellency,  protecting it against the detrimental effects of freeze/thaw cycles and salt intrusion.

APPLICATION PROCEDURES

Preparation:
Surfaces must be clean, dry, and free from oil, grease, dust, or dirt. At this point, a small test area should be applied in an inconspicuous location to test the compatibility of the coating with the prepared substrate. Allow the coating to dry and cure fully, then inspect for proper film formation, gloss, adhesion and confirm that the film is free from whitening or any other defects.

Mixing:
The material is ready for use and requires no mixing or dilution. It is unlawful to further dilute with non-exempt solvents.

Application:

TK-ONE STEP WILL DARKEN CONCRETE.
New Concrete Application: Finish trowel and allow surface water to completely dissipate. Immediately apply the product once surface water has dissipated. Use a low pressure (20 to 30 lbs.) sprayer or power sprayer and apply uniformly at the specified rate of coverage. Avoid heavy accumulations. Existing Concrete Application: Use a long nap applicator or a paint roller to distribute the compound more evenly. Back rolling is highly recommended. Avoid heavy accumulations. An airless sprayer or low-pressure spray equipment may be used on larger application areas. A second coat should be applied to surfaces that are very porous and where
absorption is rapid. Allow the coating to become tack-free between coats.

CLEAN UP
Use TK-00 XYLENE* to clean tools and equipment. Pump solvent through the sprayer to remove residue of materials which can clog the hose and wand assembly.